Click on Picture for Instructions
Keypad Model OWK-BX and Model OKP-BX
Just like our garage doors and openers, our support is the best in the business. Some say that our support puts the "genuine" in our motto, "The Genuine. The Original." because we truly care about our customers and do what it takes to make sure you are satisfied with your Overhead Door products. View the wireless programming instructions by selecting your model below. Should you need additional information about installing or programming your garage door opener or remote, please call customer service at 800-929-DOOR, or use our distributor locator to find a Red Ribbon Distributor near you.
5 Steps To Program Your HomeLink® System
Note: Some vehicles may require the ignition be turned on or the vehicle actually running to program the Homelink® transceiver.
To program a rolling code compatible Homelink® system, please follow these steps.
- Press and hold the two outside buttons on the Homelink® system until the LED starts to blink, release buttons
- Press and hold the desired Homelink® button and the transmit button on your rolling code transmitter at the same time until the Homelink® LED changes from a slow blink to a rapid blink. (Your Homelink® system is now programmed)
- Locate the learn code button on your garage door opener. (These are located under the light cover or on the rear panel depending on model)
- Press the learn code button on the garage door opener, a red LED will start to blink. (You will have 30 seconds to complete programming)
- While the LED on the garage door opener is blinking, return to the vehicle and press the pre-programmed Homelink® button 4 times. (Or until the garage door operates).